"How to assemble and program an FPV Racing Drone (2021)" - By Dilan Hern

 

"How to assemble and program an FPV Racing Drone (Guide)"

- By Dilan Hern

( https://oscarliang.com/build-racing-drone-fpv-quadcopter/ )

    Building Items include, but aren't limited to batteries (lipo's) and upgrade modules.

- Frame

- FC – Flight Controller

- Motors

- ESC – Speed Controller

- Receiver

- VTX

- Propellers

 ----->

 

 Now you can plug in the battery, go to the Motor tab in Betaflight Configurator, and try to spin up the motors one by one, and verify if the motors are spinning in the right direction.

 Next, you will configure the PID values from the flight controller to a range of values appropriate for your specific quadcopter build, thus allowing you to have a unique, user-specific flying style that can be professionally tuned over time, by using trial and error in small increments.

 

Adjust the control outputs from the inputs on your transmitter thorugh the software GUI as provided in the image above (BetaFlight). 

           Connect FPV Camera and VTX

When mounting battery, make sure the centre of gravity is as close to the centre of the drone as possible.

If the quad is back heavy for example, the rear motors will have to work harder than the front motors in order to maintain balance, and this will impact flight performance. 

           You're Done!!!

    Textual References (Below)

     - ( https://oscarliang.com/build-racing-drone-fpv-quadcopter/ )